Reeds are one of the most
important factors in developing and achieving a fine tone on any single or
double reed woodwind instrument. I sometimes tell my students to think of them as if they
were tires on your car. It's the only contact you have with the
road, so it's important that they work well. It's also important
that they be of good quality and that they are maintained well and taken
care of properly. It doesn't pay to skimp on the cost, because as
with most things you buy, you get what you pay for. High quality
reeds, and tires, for that matter, will last longer and give you better
results over time. O.K., enough for my lecture on buying high
quality reeds.
The first thing you should know about reeds
is that they are terribly inconsistent. If you buy a box of ten, you
will be lucky if three or four of them work without adjusting them.
If you are having problems with your sound, the first thing you should do
is try a different reed. Follow my instructions below when you buy a
new box of reeds. You will be amazed at the difference from one reed
to the next.
Reeds come in different strengths, graded by
thickness from a 1 (thin) to a 5 (thick). Start with a one and a
half or a two. This strength of reed is fine for beginners. Some
brands also come in filed and unfiled. The difference between the
two is subtle, so experiment to find the cut that works best for you. Do not buy into the
common misconception that the harder strength of reed that you play on, the
better you are. Most players use a medium strength reed and a medium size
mouthpiece. Michael Brecker uses a #2 or #2 1/2!
If you've heard Michael's playing, you know that a medium reed works just
fine for him. Using a reed that is too
hard will lead to the very bad habit of biting and your sound will be harsh and
out of control and out of tune. Using a reed that is too soft will
give you a weak tone, poor intonation and no projection of your
sound.
There is a procedure that you should follow
whether you are dealing with one reed or a box of five, ten or twenty (which I would
recommend). First, soak the reeds for about ten minutes in tepid
water, making sure to soak the entire reed. Push them underwater to
soak them thoroughly. An interesting thing to observe at this point
is to pull a reed out of the water and blow very hard on the butt end of
the reed. You should see tiny bubbles appearing on the vamp section
of the reed. This proves that the channels run all the way through
the reed. So, if you notice that your reed "warps" at the
tip, this is just the water being absorbed through these channels at
different rates as it soaks in to the reed. It will flatten out when
the reed is properly soaked. After soaking the reeds for ten minutes or so, pull them
out and shake off the excess water and place them flat side down on a
non-porous, flat piece of glass or plastic. Next, wet your thumb and
rub the vamp (cut) portion of the reed towards the tip about ten times.
What you are doing is sealing the pores in the reed so that it will be
slower to absorb the water. So, if perchance you do get a good
reed (a rare occurrence), it will last longer and maybe even play better. The same thing that makes
the reed work is the same thing that kills them, ...water. Let these
reeds dry overnight and repeat the soaking procedure, only this time when
you are through rubbing them, try play testing each one. You will
find that they all play different, some good, some bad. I actually
grade mine, "A" for great, "B", "C",
"D" down to "F" for really bad. A pencil works
fine for marking them. Break your reeds in gradually if
possible. Don't over blow them or practice your altissimo register! I have found that this helps to prolong their
life if you don't beat them up right away.
I would also recommend that you rotate three or four reeds at a time, so
that you always have two or three good ones to choose from. When reeds go bad, it's time to replace them. For me, if I feel the reed just doesn't respond like it should or the altissimo register just won't pop out like it usually does, or I get the general sound of a kazoo over the whole range, then I switch reeds. Reeds should last at least 15 to 20 hours of blowing, hopefully more. Anytime you're having some problem with sound, squeaking etc. switch reeds, it's the easiest thing to try first.
Some basic tools that you should have are as
follows:
- A piece of glass or plastic on which to
rub the reeds and to let them dry.
- A sharp knife for trimming and balancing
the reeds.
- Dutch Rush or some 400 grit sandpaper for
fine adjustments.
- A reed holder to store the reeds that you
are using.
- A reed clipper for trimming the end off
when it gets soft.
The basic idea behind adjusting reeds is to
take off material where the reed is too thick and to balance the reed if
one side is thicker than the other. It gets a lot more involved than
that, but as a beginner, this is a good place to start in your
understanding of reed trimming. You should try taking a reed that
doesn't work well in the first place, and experiment on it. Start by
thinning the tip a little. Hold the reed up to the light and see if
you can tell if one side looks thicker or darker than the other. Try
taking material off that side. Play the reed after every small
adjustment, sometimes a very slight adjustment can make a big difference.
You don't want to take off too much. Don't adjust the very center of
the vamp part of the reed. This is called the "heart" of the reed, and
should be left alone. See the reed adjustment chart
here.
This is a very brief summary of how to
manage your reeds. Again, I would refer you to "
The Art of Saxophone Playing
" by Larry Teal. Definitely, the one book you should own as a
Saxophone player. As far as recommending reeds, the only reeds that
I personally would recommend are the Alexander
Superials, either regular
cut or "DC" (double cut). After thirty years of searching
for the perfect reed, these come the closest. However, there are
hundreds of brands to choose from. I would stick with the better known
brands like Rico, Rico Royals, La Voz, Van Doren, Hempke. Try as many brands as you can. You will soon find a brand
that works for you , your mouthpiece, horn, and your tonal concept.
|